Ceramic Seal Rings
Product Description
Ceramic seal rings are the annular parts at a mechanical seal, a pump gland, a valve seat or an insulating joint, where a ring has to hold a sealing face flat and at the same time keep two conductive parts apart. The ring is a fit-and-flat part: the bore locates it on the shaft or the seat, the face has to be flat enough to hold the sealing film, and the two have to be square to each other, or the ring tilts and opens a gap on one side however flat the face is. Rings are usually bought as a pair, and the pair has to work together, which is why bore, face and squareness are produced in one setup rather than in separate operations.
A seal is rebuilt, not re-engineered, so the ring you fit has to match the one it replaces. We bore the ring and grind the face square to that bore on the same setup, and produce both rings of a pair from one reference, so a rebuilt seal holds again and the shaft does not have to be touched. Send the shaft size and the seat, or a worn ring, and we will match it; the setup is kept for your part number, so the next pair matches the first and your seal does not need re-lapping on site.
Specifications

Application 1. Mechanical seal assemblies. A mechanical seal holds on a film between two flat faces, and the ring's face has to stay flat and square to the shaft. A ground alumina ring keeps that film, and it resists the abrasive particles that would scratch a metal face.
Application 2. Pump glands and valve seats. A gland ring sets the clearance around a shaft and a seat ring sets where a valve closes. Alumina holds both dimensions because it does not gall or corrode against the mating part, so the clearance does not open up.
Application 3. Insulating joints in electrical equipment. Where a joint has to seal and insulate at once, the ring does both. Alumina keeps dielectric strength at temperature, so a single ring replaces a gasket plus an insulator.
Customization
Inner diameter, outer diameter, thickness, face width and chamfer are produced from drawing, in 99% or more alumina, with the face ground square to the bore. Buyers may specify face flatness, bore tolerance and the surface finish at the sealing face, and rings can be supplied as matched pairs. Drawings and samples are accepted, OEM and ODM are supported, and a custom sample takes about 15 days.
Packaging & Transportation
Rings are wrapped in bubble film and stacked in a rigid inner box with EPE between pieces so faces cannot touch. Inner boxes go into export corrugated cartons; heavy or large-diameter rings are packed in fumigated wooden cases with the IPPC mark. Cartons carry fragile, this side up and keep dry marks, and a shipping mark with order number, carton number and destination. EXW and FOB Shanghai or Ningbo are available.
Specifications
|
Parameter |
Specification |
|
Material |
99% or more alumina ceramic |
|
Bulk Density |
3.6 g/cm³ or more |
|
Hardness |
HRA90 or more |
|
Max Working Temperature |
1600°C |
|
Size Tolerance |
±0.1 mm or less |
|
Purity |
99% or more |

FAQ
Q1. Can the face be ground square to the bore?
A. Yes. The bore is established first and the face is ground square to it on the same setup, so the ring does not tilt when it is fitted to a shaft.
Q2. Do you supply rings as matched pairs?
A. Yes. Both rings of a seal pair can be produced from one reference, so a seal can be rebuilt with a replacement and still hold.
Q3. What is the minimum order?
A. Orders start at RMB 1,000 in value, which covers a trial pair or a small set.
Hot Tags: ceramic seal rings, China ceramic seal rings manufacturers, factory, Alumina Ceramic Lining Tiles, Alumina Ceramic Ring, Alumina Ceramic Rod, Ceramic Guide Rail, Ceramic Shaft Sleeve, Industrial Ceramic Balls
You Might Also Like
Send Inquiry



