Alumina Getter Plates
Product Description
Alumina getter plates are the flat ceramic plates mounted inside vacuum equipment, where they present a clean surface that helps hold a stable vacuum instead of releasing gas back into the chamber. In a vacuum system every surface is a source: a plate that was machined with the wrong finish, or one that was never cleaned after firing, outgasses for hours after pump-down and the process never settles. The getter plate is used on steel cord lines and similar vacuum processes as a stable, low-outgassing surface near the work, and its flatness and finish are its working features, because the plate seats against a carrier and any gap behind it becomes a place where gas accumulates.
Vacuum parts are bought on what they release, not only on what they are, so the plate you fit has to be clean at the surface and consistent from plate to plate. We press these plates from high-purity material, fire them in house, then finish the seating face as a separate operation to take off the fired skin that would otherwise outgas in service, and wrap each plate before it leaves. Send us the chamber fitting or a sample of the plate in use, and we will match the outline and the seating face so a replacement goes into the same carrier without a new gasket take-up.
Applications

Application 1. Steel cord wire running lines. A steel cord line depends on a stable atmosphere around the wire path, and residual gas changes the condition of the wire surface. A low-outgassing alumina plate helps hold the vacuum instead of adding to the gas load.
Application 2. Vacuum chambers with heated walls. Where a chamber runs at temperature, a polymer or porous plate becomes a gas source. A dense alumina plate stays inert at 1600°C, so it does not limit how hot the chamber can be run.
Application 3. Insulating carriers inside vacuum fixtures. The plate often doubles as an electrical barrier. Alumina provides insulation and vacuum compatibility at the same time, which removes the need for a separate insulator in a crowded fixture.
Customization
Plate length, width, thickness, hole positions and edge profile are produced from drawing, with the seating face ground flat. Buyers may specify the surface finish at the working face, the flatness band, and the purity grade required by their vacuum level. Drawings and physical samples are both accepted, OEM and ODM are supported, and a custom sample takes about 15 days.
Packaging & Transportation
Each plate is wrapped in bubble film with EPE over the finished face, then placed in a foam-lined inner box so plates cannot slide. Inner boxes are packed in export corrugated cartons; heavy stacks go into fumigated wooden cases with the IPPC mark. Cartons carry fragile, this side up and keep dry marks, and a shipping mark with order number, carton number and destination. EXW and FOB Shanghai or Ningbo are supported.
Specifications
|
Parameter |
Specification |
|
Material |
99% or more alumina ceramic |
|
Bulk Density |
3.6 g/cm³ or more |
|
Surface Roughness |
Ra0.8 or better |
|
Size Tolerance |
±0.2 mm or less |
|
Max Working Temperature |
1600°C |
|
Purity |
99% or more |

FAQ
Q1. Can the plate be machined to match an existing chamber?
A. Yes. Thickness, hole positions and edge profile are produced from your drawing, and the seating face is ground so the plate fits the chamber it was designed for.
Q2. Is the surface treated after firing?
A. The working face is finished after firing. Removing the fired skin is what keeps the plate from becoming a gas source in service.
Q3. What is the minimum order?
A. Orders are accepted from RMB 1,000 in value, which allows a single plate to be trialled in the chamber before a set is ordered.
Hot Tags: alumina getter plates, China alumina getter plates manufacturers, factory, Abrasion Resistant Ceramic Tiles, Alumina Ceramic Pipe, Ceramic Industrial Blades, Ceramic Nozzle Spray, Ceramic Shaft Sleeve, Industrial Ceramics Products
You Might Also Like
Send Inquiry

