Straight Alumina Ceramic Bars
Product Description
Straight alumina ceramic bars are the solid rods used as supports, insulating struts and locating pins inside machines, electronic equipment, chemical plant and high-temperature furnaces. A bar is the simplest ceramic shape, which is also why it is the one that quietly decides how an assembly behaves: a strut that bows in the furnace lets a load shift, a locating pin that is undersized lets a fixture drift, and a bar that is not straight loads whatever it carries instead of just holding it. The material is chosen where a metal rod would bend at temperature, conduct current or corrode, and the bar is ground between centres so the diameter and the line are produced together.
For a strut or a locating pin, the two numbers that matter are the diameter and the line, and we produce them on the same setup rather than in two operations. Bars are supported through firing, then ground between centres, with the ends finished square to the axis so a bar seats against a stop without rocking. Long lengths travel in a carrier that keeps them straight on the way to you. Tell us the bracket the bar fits and the length you need, and the replacement will drop into the same bracket as the one it replaces.
Specifications

Application 1. Furnace supports and insulation struts. A strut inside a furnace carries a load while sitting in radiant heat. Alumina keeps its line and its strength at 1600°C, and it does not conduct, so the part it supports stays isolated.
Application 2. Machine guide pins and locating bars. A locating bar sets the position of a fixture or a workpiece. A ground bar holds its diameter and its straightness, so the fixture repeats its position instead of drifting with a bent pin.
Application 3. Electronic and chemical equipment frames. Where a frame member has to be non-conductive or non-corroding, an alumina bar replaces a metal one. It does not rust in a washdown and does not carry stray current into the structure.
Customization
Diameter, length, end treatment, chamfer and any step or shoulder are produced from drawing, with the bar ground between centres for diameter and straightness. Buyers may specify the straightness band over the full length and the surface finish where a part slides along the bar. Drawings and samples are accepted, OEM and ODM are supported, and a custom sample takes about 15 days.
Packaging & Transportation
Bars are wrapped in bubble film with EPE at the ends, then packed in a rigid inner box or a carrier so they cannot flex. Long bars travel in fumigated wooden cases with the IPPC mark, blocked along their length. Cartons carry fragile and this side up marks, and a shipping mark with order number, carton number and destination. EXW and FOB Shanghai or Ningbo are available.
Specifications
|
Parameter |
Specification |
|
Material |
99% alumina ceramic |
|
Diameter Tolerance |
±0.1 mm or less |
|
Straightness |
0.1 mm/m or better |
|
Hardness |
HRA90 or more |
|
Bending Strength |
300 MPa or more |
|
Max Working Temperature |
1600°C |

FAQ
Q1. Can you grind the diameter and the straightness together?
A. Yes. The bar is ground between centres after firing, so the diameter and the line are produced on the same setup rather than separately.
Q2. How long a bar can you supply?
A. Length is agreed from the drawing and the handling route, since a long bar needs a carrier that keeps it straight from the works to the customer's store.
Q3. What is the minimum order?
A. Orders start at RMB 1,000 in value, enough for a trial bar.
Hot Tags: straight alumina ceramic bars, China straight alumina ceramic bars manufacturers, factory, Alumina Ceramic Ring, Alumina Ceramic Rod, Ceramic Getter Plate, Industrial Ceramic Rollers, Mechanical Ceramics, Sealed Ceramic Bearings
You Might Also Like
Send Inquiry


