Alumina Ceramic Tubing
Product Description
Alumina ceramic tubing is the hollow section that carries a hot gas, an aggressive liquid or an insulated conductor through equipment where a steel pipe would corrode, conduct heat away or contaminate the medium. In a process line the tube does three things: it defines the flow area, it separates what is inside from what is outside, and it holds the flow path straight where a corroded pipe would close up with scale. Tube is specified from the inside out, since the bore sets the flow or the clearance for the conductor and the wall sets what the tube can take. An off-centre bore makes one side of the wall thinner than the other, and that thin side is where a tube under heat will first crack.
Tubing is formed with the bore established first and the outside ground from that same axis, so the wall does not run thin on one side and the tube heats evenly instead of loading one side. Ends are cut and finished square to the axis, with a chamfer or a step where your fitting calls for one, so the tube seats against a flange without a gap. Send the fitting or the bore you need to hold, and we will produce the tube to that inside dimension rather than to a stock pipe size, then keep the drawing and the setup for your reorders.
Specifications

Application 1. High-temperature gas and liquid lines. A metal tube in a hot line oxidises and its bore closes up with scale. An alumina bore stays clean at 1600°C, so the flow area does not change over the campaign.
Application 2. Insulated conductor protection. Where a conductor passes through a hot or damp zone, the tube has to insulate as well as protect. Alumina holds dielectric strength at temperature, so the conductor is isolated without a separate sleeve.
Application 3. Chemical and abrasive slurry piping. Acid or abrasive slurry wears a steel pipe from the inside out. Alumina resists both, and the tube can be replaced on its own rather than cutting and re-welding the line.
Customization
Outer diameter, inner diameter, wall thickness, length and end treatment are produced from drawing, with bore and outside diameter ground from a common axis. Buyers may specify concentricity, the surface finish inside the bore for flow, and whether the ends need a square cut, a chamfer or a step for a fitting. Drawings and samples are accepted, OEM and ODM are supported, and a custom sample takes about 15 days.
Packaging & Transportation
Tubes are wrapped in bubble film with EPE at both ends, then packed in an inner box or a tube carrier so the bore edge is not chipped. Inner boxes go into export corrugated cartons; long or heavy tubes travel in fumigated wooden cases with the IPPC mark. Cartons carry fragile, this side up and keep dry marks, and a shipping mark with order number, carton number and destination. EXW and FOB Shanghai or Ningbo are available.
Specifications
|
Parameter |
Specification |
|
Material |
99% or more alumina ceramic |
|
Bulk Density |
3.6 g/cm³ or more |
|
Compressive Strength |
2000 MPa or more |
|
Max Working Temperature |
1600°C |
|
Size Tolerance |
±0.5 mm or less |
|
Purity |
99% or more |

FAQ
Q1. Can you hold the wall thickness around the circumference?
A. Yes. The bore is established first and the outside is ground from the same axis, so the wall does not run thin on one side.
Q2. Are tube ends ready to fit?
A. Ends are cut and finished square to the axis, with a chamfer or a step where the drawing calls for one, so the tube seats against a fitting without a gap.
Q3. What is the minimum order?
A. Orders start at RMB 1,000 in value, which covers a trial length for one position.
Hot Tags: alumina ceramic tubing, China alumina ceramic tubing manufacturers, factory, Abrasion Resistant Ceramic Tiles, Alumina Ceramic Ring, Ceramic Gasket Sheet, Ceramic Nozzle Spray, Ceramic Shaft Sleeve, industrial ceramics
You Might Also Like
Send Inquiry










