Ceramic Conveyor Rollers
Product Description
Ceramic conveyor rollers are the idler rollers that support a moving belt or carry bulk material along a conveyor. On a conveyor the roller turns continuously under load, in dust, moisture and often in material that is abrasive, and a steel roller in that position rusts, wears into a hollow and eventually seizes, which drags the belt and puts the drive under strain. A ceramic roller body keeps its diameter while it wears, does not corrode in a wet line, and does not conduct, so a roller sitting near a live part or an electrostatic-sensitive product does not carry current into the frame. The body is formed and the outside is ground, with the bore and the end faces finished so the roller runs true on its shaft.
Replacing rollers one by one is a maintenance job nobody wants to repeat, so the rollers you fit should last and should arrive interchangeable. We grind the outside diameter of each roller on the same setup and finish the bore and the ends from that same axis, so a set sits at one height and the belt does not run at an angle. Rollers are supplied to your shaft size, and the diameter band is held across the batch, so you can pull any roller from the crate and fit it without measuring first.
Applications

Application 1. Bulk material conveyor lines. A line carrying abrasive bulk material wears a steel idler until the belt starts to track off centre. A ceramic body holds its diameter far longer, and the belt keeps running on a stable set of support points.
Application 2. Mining and mineral processing conveyors. Wet, gritty conditions rust steel rollers and seize their bearings. The ceramic body does not corrode, so the roller keeps turning and the belt is not dragged over a seized idler.
Application 3. Chemical plant and washing conveyors. Conveyors in chemical plants are exposed to washdown and to product that attacks metal. Alumina resists both, and its insulation means the roller does not carry stray current into the frame.
Customization
Outside diameter, length, bore diameter and bore position are produced from drawing in 99% alumina, with the outside diameter ground to the tolerance the line requires. Buyers may specify the end profile where the roller seats in its bracket, and the surface finish needed for the belt being carried. Drawings and samples are accepted, OEM and ODM are supported, and a custom sample is normally ready in about 15 days.
Packaging & Transportation
Rollers are wrapped in bubble film with EPE at both ends, then packed in an inner box and an export corrugated carton. Long or heavy rollers are placed in fumigated wooden cases carrying the IPPC mark, with the pieces blocked so they cannot roll against each other. Cartons show fragile and this side up marks, and a shipping mark with order number, carton number and destination. EXW and FOB Shanghai or Ningbo are supported.
Specifications
|
Parameter |
Specification |
|
Material |
99% alumina ceramic |
|
Bulk Density |
3.6 g/cm³ or more |
|
Compressive Strength |
2000 MPa or more |
|
Hardness |
HRA90 or more |
|
Max Working Temperature |
1500°C |
|
Size Tolerance |
±0.5 mm or less |

FAQ
Q1. Can you keep all rollers in one order at the same diameter?
A. Yes. Rollers are ground against a common reference after firing, so a set sits at one height rather than needing shims under individual pieces.
Q2. How much lighter is a ceramic roller than steel?
A. The weight difference is set by the wall section of the roller and is quoted with the drawing rather than assumed, since the bore and wall are both customer-specific.
Q3. What is the order minimum?
A. Orders start at RMB 1,000 in value, which covers a trial set for one conveyor position.
Hot Tags: ceramic conveyor rollers, China ceramic conveyor rollers manufacturers, factory, Alumina Ceramic Pipe, Ceramic Guide Rail, Ceramic Nozzle Spray, Industrial Ceramic Balls, Industrial Ceramics Products, Sealed Ceramic Bearings
You Might Also Like
Send Inquiry

