
Wear Resistant Ceramic Blocks
Product Description
Wear resistant ceramic blocks are the thick-section pieces fixed where bulk material does not slide but strikes: the transfer point of a chute, the inlet of a hopper, the throat of a fan, the deck of a kiln car. A block differs from a thin liner tile in that it has enough section to absorb an impact without cracking and enough mass to stay in place under a load that arrives at an angle rather than along the surface. Blocks are held by bolts or by a frame, so the fixing holes and the chamfered edges are formed to the drawing; a hole in the wrong place either cracks the block or leaves it loose, and a sharp corner is where the first crack starts. The face takes the stream, the section absorbs the blow.
An impact block usually fails at the corner or at the fixing hole long before the face wears out, so we form the section and the edges with that in mind, chamfering the loaded corner and finishing around the bolts so no sharp transition is left where a crack can begin. Blocks made for one fixing frame are produced at a common thickness, so a worn block can be swapped without re-shimming the frame or leaving a step the material then attacks. Give us the frame drawing or a worn block, and the replacement will seat flush with the ones beside it.
Specifications

Application 1. Chute transfer points. Material changing direction hits the wall rather than sliding along it, so the block has to absorb an impact load without cracking. A thick alumina section takes that load and keeps the transfer point's profile intact.
Application 2. Hopper inlets and fan throats. These are the places where a liner is destroyed first, because the particle stream is still accelerating. A block with a chamfered edge keeps its section and does not spall at the corner where the stream lands.
Application 3. Mixer and kiln car wear zones. A mixer paddle or a kiln car deck is struck repeatedly at the same place. Blocks fixed to that zone spread the load and can be replaced individually, which is cheaper than replacing the whole deck or paddle.
Customization
Block length, width, thickness, chamfer, curved face and fixing hole layout are produced to drawing in 95% or 99% alumina. Buyers may specify the impact direction so the chamfer and the section are placed on the loaded side, and the hole pattern of the frame the block is fixed to. Drawings and samples are accepted, OEM and ODM are supported, and a custom sample takes about 15 days.
Packaging & Transportation
Blocks are wrapped in bubble film with EPE on the corners, then crated in a sized inner box so heavy pieces cannot knock together. Inner boxes go into export corrugated cartons for lighter blocks; heavier consignments are packed in fumigated wooden cases with the IPPC mark and blocked to prevent movement. Cartons carry fragile and this side up marks, and a shipping mark with order number, carton number and destination. EXW and FOB Shanghai or Ningbo are available.
Specifications
|
Parameter |
Specification |
|
Material |
95% or 99% alumina ceramic |
|
Hardness |
HRA90 or more |
|
Bulk Density |
3.6 g/cm³ or more |
|
Compressive Strength |
2000 MPa or more |
|
Max Working Temperature |
1500°C |
|
Size Tolerance |
±0.5 mm or less |

FAQ
Q1. Can you produce blocks to our fixing frame?
A. Yes. The hole layout and thickness are taken from the frame drawing, so the block seats flush and does not need shimming or drilling on site.
Q2. Do thicker blocks wear proportionally longer?
A. Wear life is set by the material and the impact angle as well as by thickness, so the section is agreed with the service conditions rather than simply increased.
Q3. What is the minimum order?
A. Orders start at RMB 1,000 in value, enough for a trial block at one impact point.
Hot Tags: wear resistant ceramic blocks, China wear resistant ceramic blocks manufacturers, factory, Ceramic Base, Ceramic Gasket Sheet, Ceramic Nozzle Spray, Industrial Ceramic Balls, Industrial Ceramic Rollers, industrial ceramics
You Might Also Like
Send Inquiry
